大家好
*7!MG 我照說明書上安裝到一半就不會了
46:<[0Psl/ 首先安裝時我選PTC License Server 然後看我的host ID 接著關閉這個安裝 因為他找不到檔案
s@\3|e5g 接著我把 license.dat 的 00-00-00-00-00-00改成我的host ID ,全部都改,
0?7yM:!l 接著安裝Pro /ENGINEER 直到完成
-n _Y.~ 最後要再回頭裝PTC License Server 它仍然找不到授權檔案
H/D=$)3op 我該怎麼裝才可以呢? 請教我 謝謝
.vu7$~7 以下附上安裝說明檔
t+?Bb7p,H N<)CG,/w[M 1) Start pro/e setup
M) bQvjj FuHBzBoM= 2) Open license.dat with any txt-editor and replace every occurance of 00-00-00-00-00-00 with your computer real HOST_D (same one shown in the bottom left corner of the Pro/e setup). Save the license.dat
@;/Pl>$|'G d0aXA+S% 3) Install proe - proe_mech -ptc_distributed_services (optional). On license-config screen select "nodelocked license" and point to edited license.dat
A!lZyG!3 E|@C :ghG Next apply a patches (if u didn't install the complete package, you will get "File not found" errors, accept or bleed)
bY~K)j
v3& |bnd92fvks for pro/engineer:
)d3
09O Copy "proe_WF5_Win64_crk.exe" to folder <proeWildfire 5.0 progdir>\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
g NI1W@) 6<&A}pp for pro/mechanica
dSGdK
$ XA Copy "proe_mech_WF5_Win64_#1_crk.exe" to folder <proeWildfire 5.0 progdir>\i486_nt\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
s%jBIeh Copy "proe_mech_WF5_Win64_#2_crk.exe" to folder <proe mech WF5 progdir>\i486_nt\ptc and click "Start > OK"
!1$x4 qxS 1 w>[ for ptc distributed services
w S Copy "ptc_distributed_services_WF5_Win64_crk.exe" to folder <ptc_distributed_services WF5 Win64 progdir>\i486_nt\obj and click "Next > OK > Finish > OK"
:\ ;9y3 I-# !mFl That's all.. Enjoy :)
