[求助]卡塞格林望远镜到单模光纤的耦合效率 [复制链接]

各位大侠，我是菜鸟初学者，请问zemax可不可以做卡塞格林望远镜到单模光纤的耦合效率分析，望远镜和光纤之间还要加透镜的吧，哪里可以体现耦合效率呢？谢谢了！

jdgx0801:能不能列出一些例子作为参考呢？觉得还是比较难啊 (2015-05-20 16:28)  I[MgIr^  

$DFv30 f  
     M/D)".;  
I don't have a particular file myself, however the folder Zemax\Samples\Physical Optics contains an example, Fiber Coupling.ZMX, making use of POP to model the coupling. Its a very simple example but does contain some setup you may wish to refer to at the beginning.

hopebox:Apologies for late reply as I have been away for a while. The tab "Beam Definition" has a top hat which can be used as collimated beam and the receiving fiber end can be defined under the tab Fiber Data. If you have a single mode you can pick up a B .. (2015-05-07 17:45)  U=Y)V%  

sRVIH A,  
能不能列出一些例子作为参考呢？觉得还是比较难啊

hgdjoe:请教：光源为准平行光  而接收光纤为10微米0.15的单模光纤在pop如何设置呢 (2015-04-22 11:02)  84HUBud76Y  

^m#-9-`  
Apologies for late reply as I have been away for a while. The tab "Beam Definition" has a top hat which can be used as collimated beam and the receiving fiber end can be defined under the tab Fiber Data. If you have a single mode you can pick up a Beam Type to closely match your fiber mode and then define the other physical parameter accordingly.

hopebox:using Calcualtion > Fiber Coupling Efficiency or Geometric Image Analysis or Physical Optics Propagation
there are three option depending on your system set up and the actual modelling you wish to perform  (2010-06-25 20:04)  N@B9 @8h  

|AZg*T3:W  
请教：光源为准平行光  而接收光纤为10微米0.15的单模光纤在pop如何设置呢

卡塞格林望远镜的口径250MM吗 ?UM*Xah  

设计过300mmRC耦合，多种单光路和多光路的光纤耦合，可以联系yaoyaogr@126.com

thanks a lot!

using Calcualtion > Fiber Coupling Efficiency or Geometric Image Analysis or Physical Optics Propagation `-LGU7~+  
Bj7gQ%>H4  
there are three option depending on your system set up and the actual modelling you wish to perform

望远镜的实际焦距是3m,已经加了透镜将焦距缩短到了1m左右，利用光纤的口径代替光阑限制望远镜的视场角，望远镜视场角大概为0.1mrad，口径为250mm,工作波段在532nm,光纤数值孔径为0.1，半径2微米。应该从望远镜出来的光要经过透镜之类的才能耦合进单模光纤吧，这个透镜要怎么设计啊，另外zemax也是初学，单模光纤也不太会弄，谢谢指教！