| hopebox |
2012-07-25 21:00 |
you could check the following: % E 8s>D
:xC1Ka%~
- if the surface/element tilt is too large u\u6< [>P
u > [hLXuB
- enough analysis rays used? cCq mrjUmV
WTUC\}#E\
- have you used Coherent Data option under Detector setting. 3<}r+, j
8jz7t:0
Someone above was right about that the non-sequential mode only uses geometric rays but you could see inteference fringes using Coherent Data.
|
|