哪些操作数可以控制后工作距-ZEMAX,OpticStudio-光行天下-最大的光电技术社区-光学,光电,光机技术及其软件运用交流社区!

首页 -> 登录 -> 注册 -> 回复主题 -> 发表主题

光行天下 -> ZEMAX,OpticStudio -> 哪些操作数可以控制后工作距 [点此返回论坛查看本帖完整版本]

[打印本页]

fumm20	2011-01-12 11:07
哪些操作数可以控制后工作距各位大侠： .3SjkC4I 我要设计一套光学系统，后工作距为90mm，请问在优化过程中使用哪些操作数可以保证后工作距为90mm？ Xpz-@fqKdf

mtiger2008	2011-01-12 17:19
你明白后工作距的物理意义就知道怎么控制了 TgG)btQ 透镜最后一个面到像面的距离 r,@\|Snv) 所以你限制好最后一个空气间隔的长度为90就可以了

hopebox	2011-01-12 17:56
Using Operand TTHI should do the job for you. If you take a look of the example, Double Gauss 28 degree field.zmx, in ZEMAX and using the settings shown in the following picture, you will notice the TTHI returned is the distance between the last refractive surface and the image plane is returned. Hope this solves the question you had.

hopebox	2011-01-12 17:56
My apologies, no picture but set surf 1 and Surf 2 = 11 in the aformentioend example.

mtiger2008	2011-01-12 19:07
呵呵，楼上的英文不错 $a]dxRkz 羡慕

fumm20	2011-01-12 19:59
引用第1楼mtiger2008于2011-01-12 17:19发表的 : R["7%\|RV 你明白后工作距的物理意义就知道怎么控制了 EtG)2) 透镜最后一个面到像面的距离 %stktVDAP 所以你限制好最后一个空气间隔的长度为90就可以了 V19*~v=u Cm>F5$l{ 谢谢我明白了

fumm20

2011-01-12 20:00

引用第2楼hopebox于2011-01-12 17:56发表的 : ^S@b*
Using Operand TTHI should do the job for you. If you take a look of the example, Double Gauss 28 degree field.zmx, in ZEMAX and using the settings shown in the following picture, you will notice the TTHI returned is the distance between the last refractive surface and the image plane is returned. Hope this solves the question you had. Z$@Nzza-

Thanks you very much! I have getten a success!

hopebox	2011-01-13 00:27
I am glad it helps ;)

查看本帖完整版本: [-- 哪些操作数可以控制后工作距 --] [-- top --]